*NOTE : This process is only for units just taken out of the box with the magnets still attached to the unit, if you have removed the magnets and did not see Strips added to your gateway, please try the Manual wake-up pattern to add the device.
-How to add strips Comfort/Drip using auto-add mode to your Z-Wave controller
- 1. Set your controller to "Add-mode"
- 2. Remove magnet and place Strips on a flat surface
- 1 Short LED blink indicates auto-add has been initiated
- 3. 1 Long LED = Success!
- 5 Short blinks = Fail (Try manual-add)