- How to put your Strips Guard back in auto-add mode
- 1. Check that strips is in "Demo Mode" by placing squared magnet towards the straight edge for 2 seconds...
- When you remove magnet, you will see 2 short LED blinks
- If 1 blink. Strips is included and is connected to gateway
- If 5 blinks : Do a "reset" and try again
- Now you are ready to put Strips in auto-add mode
- 1. Place round magnet to round edge, place rectangular magnet to straight edge
- Leave for 15 seconds
- Put your gateway in add-mode
- Remove magnets from Strip
- 1 Long led blink = Success!
- 0 Blinks = Try "manual-add"
- 5 short blinks = Fail, try moving closer to the gateway and try again
Comments
0 comments
Please sign in to leave a comment.